ENGINE PREHEATER SHOULD BE USED WHEN THE TEMPERATURE IS BELOW 30 DEGREES

PREHEATING INSTRUCTIONS
 

Note:  Preheating operations should be conducted out side of the hangar.

1.  Pull preheater out of the hangar.

2.  Put hose in air intake, using notched sponge to hold hose, place second sponge in the other side.

3. Slowly open fuel tank valve all the way.

4.  Turn on fan motor.  Toggle switch is behind the fuel pressure gauge.  Failure to turn on the fan could
      result in a fire or at the worst, an explosion.

5.  Depress red button above gage and hold down.  Gage should read between 5 to 6 psi.  To increase
      pressure and heat, turn the large red regulator knob clockwise.  Do not exceed 10 psi.

6.  Push large red igniter button on the left while holding the red regulator button down until lit.
      (4 to 5 seconds)

7.  At 0 degrees, plan on 15 minutes for a good preheat.

8.  To shut down,  turn fuel tank valve off completely.  Turn off fan after 10 to 15 seconds of cool down
      time.

9.  Return the preheater to where you found it with all parts attached, ready for the next preheat job.